
EAGLE™
Quick Start
For complete documentation, go to:
http://www.rainforestautomation.com/eagle_support 1
V2.01
EAGLE™
Energy Access Gateway Link to Ethernet
Quick Start Guide
Legal Notices
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by the manufacturer could void the user’s authority to
operate the equipment.
FCC/IC RF Exposure Statement
This equipment complies with FCC and Industry Canada radiation exposure limits set forth for an uncontrolled environment. The
antenna(s) used for this equipment must be installed to provide a separation distance of at least 8 inches (20cm) from all persons.
ICES-003 Compliance
This Class B digital apparatus complies with Canadian ICES-003.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Compliance Regulations For Australia and New Zealand
This equipment complies with the C-Tick labeling requirements for Australia and in New Zealand. As a radio transmitter, this device
complies with the requirements of AS/NZS 4268:2008 as designated in the Radiocommunications (Short Range Devices) Standard
2004 for Australia and as required by the Radiocommunications Regulations (General Users Radio License for Short Range
Devices) Notice 2011 for New Zealand. This device is a Category A device as defined in the Radiocommunications (Compliance
Labeling - Electromagnetic Radiation) Notice 2003.
Software Licensing
The software included in this product contains copyrighted software that is licensed under the GPL. A copy of that license is
included at the end of this document. You may obtain the complete Corresponding Source code from us for a period of three years
after our last shipment of this product, which will be no earlier than 2011-08-01, by sending a money order for USD$5 plus
international postage from Canada to: GPL Compliance Division, Rainforest Automation, 34 West 7
th
Ave, Vancouver, BC, V5Y 1L6.
Please write “source for EAGLE ” in the memo line of your payment. You may also find a copy of the source at:
https://www.freescale.com/webapp/sps/download/license.jsp?colCode=L2.6.35_MX28_SDK_10.12_SOURCE&appType=file2&locat
ion=null&DOWNLOAD_ID=null
This offer is valid to anyone in receipt of this information.
Kommentare zu diesen Handbüchern